| Home |1 | |2 | |3 | |4 | |5 | |6 | |7 | |8 | |9 | |10 | |11 | |12 | |13 | |14 | Home |
How To Make a One-Way Valved Lid
Step 3
| Home |1 | |2 | |3 | |4 | |5 | |6 | |7 | |8 | |9 | |10 | |11 | |12 | |13 | |14 | Home |
Starting to drill now. Because of the space the clamp takes up, your valves will always end up near the edges. Be sure to pick a fresh spot on the backer board before drilling! If you try to drill in the same spot you will end up with a ruined lid.
| Home |1
| |2
| |3
| |4
| |5
| |6
| |7
| |8
| |9
| |10
| |11
| |12
| |13
| |14
| Home |
Copyright © 1999 - 2004 KKS Associates. All rights reserved